The bench press on an inclined bench is the most important exercise for the development of the upper and lower chest. In this article, we will consider four options for the bench press - at angles of 30, 45 and 60 degrees (on top of the chest) and bench press upside down (on the bottom).
When you do a bench press on a horizontal bench, work:
We are specifically interested in nursing. It is believed that a regular classic bench press evenly pumps the entire chest. However, the main load in its implementation falls on its central part. If the top or bottom of the chest looks much smaller than we would like, various options for the press at an angle come to the aid.
When we move the body to an inclined position, the main working muscle groups do not change, but the load distributed differently.
We can purposefully make the upper or lower chest work.
Redistribution of load depending on the angle:
This is a proven way to pump your lower chest.
Thus, by varying the technique of the press, you can build the desired relief of the chest.
It is not recommended to use the bar bench press on an inclined bench as an independent exercise. It is better to do it after basic exercises, for example, after a classic bench press. In extreme cases, after push-ups on bars with weights.
First you need to give a heavy overall load, and only then you can begin to work on specific areas of the pectoral muscle.
The bench press lying on an inclined bench is very useful for beginners for the uniform development of the entire mass of the upper body.
Here are a few schemes, using which you can reasonably load the entire area of the pectoral muscles.
We perform the exercises in this order:
This scheme is a superset on the pectoral muscles:
In the same way, we carry out the wiring. After three approaches you can relax.
If you wish, you can repeat the superset if you still have strength.
If you want to highlight the bottom of your chest, then the bench press on a bench with a downward inclination is ideal for these goals.
As already mentioned, there is no point in doing such a bench press as an independent exercise.
If you did not make the base that day, then try to complete at least 3 chest exercises.
For example :
The first exercise is performed in 3-4 sets and 8 repetitions, the second - 10 times, and the third - also 10 times in two or three sets.
Be guided by your condition.
If you have enough strength, do 3-4 approaches in each exercise. Between sets, a break of 60-90 seconds, between exercises - 90 seconds.
If you work to failure on the bench, rest a little more as you need. Just remember that too long rest leads to a "cooling" of the muscles.
And on the "cold" muscle, you can get stretching.
You need to press down with your head in those cases when the lower part of the chest is far behind. Bodybuilders usually use this exercise to compete effectively. The rest is enough to do a horizontal bench press and bench press on a bench with an inclination up.
And a good piece of advice: when you do the bench press on a bench with a downward slope, ask your partner or coach to help you.
You will need help with weight gain. The bar is usually taken from the floor. In the position in which you will be, it will be quite difficult to take it. Especially if the barbell weighs 50 kg or more. Still, do not remove from racks.
Although some gyms are quite well equipped and allow you to conveniently do such things.
Finally, we reached the most important thing. Now you know why to make an inclined press, it's time to learn how to do it correctly!
As always, we start with a warm-up. For starters, an empty neck is suitable, you will need to do 10-15 repetitions at an average pace, but without throwing sharply up and down.
Sit on it so that the pelvis is pressed to the seat, and the back to the back. Place your legs apart and rest your heels on the floor.
Control the movement at each stage! There is no need to throw the barbell on the chest, as well as no need to uncontrollably push it up.
When you do the required number of warm-up repetitions - put the bar back, hang the working weight and do 3 sets of 8 repetitions.
Before you begin training, pay attention to a number of important points.
It is more difficult to remove the bar with an inclined press than with a classical one. So you need an assistant.
Ask someone to help lift your barbell. While you are doing the exercise, let the person stand nearby. Putting the bar back is no less difficult, so here you will need to help.
When you work with a weight of 60-75% of the maximum, you can do it all yourself. Failing approaches require insurance.
During the exercise, you lean on your buttocks, back and legs. Typically, beginners tear off the pelvis from the bench. With an inclined bench press, this is even more dangerous than with a classic bench press, since the weight puts pressure on you in a vertical plane (albeit slightly).
Do not take your pelvis from the bench!
When you try to get into the bridge in such a bench, any meaning is lost at 45 or 30 degrees. Due to your bridge, you reset this angle.
So you do not need to bend, a natural deflection in the lower back is enough.
The trainer can put you a bench press in Smith after the classic. This is normal and allows you to isolate the top of the chest in isolation. Everything is done here in the same way as when working with a free barbell. Only the task is easier - the bar is fixed and moves strictly in a vertical plane.
The best thing, of course, is to work with free weights. Let other muscles connect to stabilize the position of the bar.
If your back beam of deltoids hurts, this will not affect the inclined bench. If the middle or front - everything is much more complicated.
Decide, by experiment with light weights, at what angle you are more comfortable pressing.
If the pain haunts you in absolutely any press, you will have to exclude these exercises for a month or two.
If, for example, at an angle of 45 degrees you don’t feel pain, you can work. But those exercises in which you feel discomfort need to be ruled out.
Before exercise, warm up well, use special ointments. Listen carefully to your body.
If pain appears somewhere, stop exercising immediately! When warmed up, the athlete may not immediately understand that a sprain has occurred. This will manifest itself after training, when the muscles have cooled.
It may not hurt you to press the barbell head down. The shoulders in it are not as much involved as the triceps and chest.
If you divide the exercises on the chest for 2-3 days, then you can do different types of presses 3 times a week.
For example, a bench press at an angle of 30 degrees in the first workout, after it, wiring and a bench press of dumbbells at 45 degrees.
In the second workout, after push-ups on the bars, you can make an inclined bench sitting at 45 degrees and finish with the same wiring.
If you alternate light and heavy workouts, you should do the same thing, but with current weights. For example, if today is easy training, weights should be less than your failures.